Dish Tv Remote Control Views

General Goods

Program DVD, VCR, Stereo Receiver, and Stereo Amplifier Code The AV1 and AV2 switch positions can be setup to control a VCR, DVD, STEREO, second DIRECTV Receiver or second 1. Turn on the component you wish to control (e.g. your DVD Player). 2. Locate the 5-digit code for your component. 3. Slide the MODE switch to the AV1 (or AV2) position. 4. Press and hold the MUTE and SELECT keys at the same time until the green light under AV1 (or AV2) flashes twice, then release both keys. 5. Using the NUMBER keys, enter the 5-digit code for the brand of component being set up. If performed correctly, the green light under the selected position flashes twice. 6. Aim the remote at your component and press the PWR key once. The component should turn off; if it does not, repeat steps 3 and 4, trying each code for your brand until you find the correct code. 7. Repeat steps 1 through 6 to set up a new component under AV2 (or AV1).

Once you have set up the DIRECTV Universal Remote Control using the above steps, use the following instructions to find out the 5-digit code to which your component responded: 1. Slide the MODE switch to the appropriate position. 2. Press and hold the MUTE and SELECT keys at the same time until the green light under the selected switch position flashes twice, then release both keys. 3. Enter 9-9-0. (The green light under the selected switch position flashes twice.) 4. To view the first digit in the code, Press and release then number 1 key. Wait three seconds, and count the number of times the green light flashes. Write this number down. 5. Repeat step 4 four more times for the remaining digits; i.e., press number 2 for the second digit, 3 for the third digit, 4 for the fourth digit and 5 for the final digit.";"821

Remote Control Manual How to program devices into the Dish Network remote control How to perform a Power Scan to search for devices How to determine the current remote control settings How to change the remote address of you Dish Network satellite receiver and remote control Television device codes VCR device codes Amplifier device codes Cable Box device codes Dish 500 Remote Control Address Links / Mirror

I have been trying to program my SONY RM-YD017 remote control to control my Dish Satellite with no results, can someone help me out on this? When you say d“Adress ” bottom what do you mean? I did try to do the opposite, program my Dish Remote to control my new Sony LCD HDTV with no results either. Help please